Category: Mod-Kits
Der SD2SP2 wird in den Seriellen Port 2 deiner Nintendo GameCube eingesteckt. Er wird verwendet, um Homebrew auf der Nintendo GameCube zu laden, wie zum Beispiel Swiss und Backup-Spiele.
Hinweis:Du benötigst eine Möglichkeit, um in das Gerät zu booten, wie zum Beispiel einen Raspberry Pi Pico, GCLoader oder eine Action Replay Disc.
I was expecting a fiddly install but this little board just clicks into Serial Port 2 and stays put—I've had zero disconnects during play. Loaded Swiss within a minute and the backup games run without a hitch.
Slots right into Serial Port 2 with zero wobble, and once Swiss boots it reads games flawlessly. I was up and running within minutes of popping it in, no soldering or fuss. Exactly what I needed to breathe life back into my old cube.
Took a gamble on this little adapter since my GameCube's disc drive is basically dead, and it's been a total lifesaver for booting Swiss from an SD card. Fits snugly into Serial Port 2 with zero wiggling, and the connection to my Raspberry Pi for the initial boot was simple enough that I had it runn
