Category: 改造キット
SD2SP2はNintendo GameCubeのシリアルポート2に接続します。これは、SwissやバックアップゲームなどのホームブリューをNintendo GameCubeで起動するために使用されます。
注記：Raspberry Pi Pico、GCLoader、またはAction Replay Discなどのデバイスから起動する方法が必要です。
I was expecting a fiddly install but this little board just clicks into Serial Port 2 and stays put—I've had zero disconnects during play. Loaded Swiss within a minute and the backup games run without a hitch.
Slots right into Serial Port 2 with zero wobble, and once Swiss boots it reads games flawlessly. I was up and running within minutes of popping it in, no soldering or fuss. Exactly what I needed to breathe life back into my old cube.
Took a gamble on this little adapter since my GameCube's disc drive is basically dead, and it's been a total lifesaver for booting Swiss from an SD card. Fits snugly into Serial Port 2 with zero wiggling, and the connection to my Raspberry Pi for the initial boot was simple enough that I had it runn
